Cisco Cisco Firepower Management Center 4000 Guía De Instalación
3-14
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
Chapter 3 Installing Cisco NGIPS for Blue Coat X-Series
Installing Cisco NGIPS for Blue Coat X-Series
Step 2
Set the MTU size for every circuit (including template circuits) in the VAP group. For example:
CBS# configure circuit circuit_name
CBS(conf-cct)# vap-group vap_group_name
CBS(conf-cct-vapgroup)# mtu
MTU_size
CBS(conf-cct-vapgroup)# end
CBS#
where
circuit_name
is the name of the circuit,
vap_group_name
is the name of the VAP group and
MTU_size
is the MTU size. For example, to set the MTU to 9000 on the circuit named
n6g7
on a VAP
group named
ABC
, enter the following:
CBS# configure circuit n6g7
CBS(conf-cct)# vap-group ABC
CBS(conf-cct-vapgroup)# mtu 9000
CBS(conf-cct-vapgroup)# end
CBS#
Note
You must configure both circuits in a bridge with identical MTU sizes.
Step 3
To complete the process of enabling jumbo frame support, reload the VAP group by entering the
following:
following:
CBS# reload vap-group vap_group_name
where
vap_group_name
is the name of the VAP group.
For more information, see the XOS Command Reference Guide.
Installing Cisco NGIPS for Blue Coat X-Series
To install Cisco NGIPS for Blue Coat X-Series, you must perform the following steps:
•
Transfer the application to the Control Processor Module (CPM), as described in
•
Install and configure the application on the VAP groups, as described in
.
•
Verify the installation, as described in
In this section, the Cisco NGIPS for Blue Coat X-Series package displays
3D Sensor
on the monitor as
the application name of the Cisco NGIPS for Blue Coat X-Series application. It is not the name you give
the device, VAP, or VAP groups you create.
the device, VAP, or VAP groups you create.
Note
https://support.sourcefire.com/
) and check for updates to the FireSIGHT System, which you can apply
using the Defense Center. The release notes accompanying each update include instructions for
installing the new software.
installing the new software.
Loading Cisco NGIPS for Blue Coat X-Series on the CPM
After you set up VAP groups and circuits, load Cisco NGIPS for Blue Coat X-Series onto the X-Series
Control Processor Module (CPM).
Control Processor Module (CPM).