buell s1 lightning '97 Manual
3-11
CYLINDER HEAD
REMOVAL
Before removing the cylinder head assembly, see
on
. The rocker arm covers and internal components
must be removed before removing cylinder heads.
1.
See
Remove screws (1) and fiber seals (2).
Discard fiber seals.
1
CAUTION
All washers and fasteners used in the V
2
TM
engine are
hardened. Do not mix or replace hardened washers and
fasteners with unhardened parts. Do not reuse fiber
cover seals. These actions may result in accelerated wear
and increased noise.
fasteners with unhardened parts. Do not reuse fiber
cover seals. These actions may result in accelerated wear
and increased noise.
2.
Remove top (4) and middle (5) sections of rocker box.
Remove and discard gaskets (6, 7 and 8).
Remove and discard gaskets (6, 7 and 8).
Figure 3-5. Rocker Arm Cover
1.
Screws (4)
2.
Fiber seal (4)
3.
Umbrella Valve (2)
4.
Upper rocker cover
5.
Middle rocker cover
6.
Gasket
7.
Gasket
8.
Gasket
9.
Rocker arm shafts
10. Rocker arm
11. Rocker arm
12. Bolt and washer (2)
13. Bolt and washer (2)
14. Screw and washer (2)
15. Bolt and washer (3)
16. Gasket
17. Gasket
18. Lower rocker arm cover
19. Rocker arm bushing (8)
11. Rocker arm
12. Bolt and washer (2)
13. Bolt and washer (2)
14. Screw and washer (2)
15. Bolt and washer (3)
16. Gasket
17. Gasket
18. Lower rocker arm cover
19. Rocker arm bushing (8)
5
3
7
4
1
2
6
12
13
14
9
8
10
19
11
15
16
17
18
xlhrock