CyberData Part #010861 Manual De Usuario

 Installing the VoIP Loudspeaker Amplifier

Restore the Factory Default Settings

VoIP Loudspeaker Amplifier Operations Guide

930106C

CyberData Corporation

27

2.6 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a 
known state.

Each loudspeaker amplifier is delivered with factory set default values for the parameters indicated 
in 

. Use the RTFM switch on the loudspeaker amplifier face to restore these parameters to 

the factory default settings. 

When you use the RTFM switch, the factory default settings are restored for only the parameters 
indicated in 

. The other parameters in the current loudspeaker amplifier configuration 

will remain unchanged.

To restore these parameters to the factory default settings:

1. Press and hold the RTFM switch for 20 seconds.

2. The loudspeaker amplifier will beep after one second. Continue to hold the switch until the 

loudspeaker amplifier beeps again after 20 seconds.

3. Release the switch. The following occurs:

•

A voice message announces that the factory default settings are being restored.

•

Once the settings are restored, a voice message announces the restored default IP address:

   192.168.3.10 

•

A voice message announces that the loudspeaker amplifier is rebooting.

•

The loudspeaker amplifier reboots.

IP Addressing

static

IP Address

192.168.3.10

Web Access Username

admin

Web Access Password

admin

Subnet Mask

255.255.255.0

Default Gateway

192.168.3.1