fisher--paykel dd605 Manual De Usuario

599464 

 

18

Once the fault has been cleared for an F3, F8 or F9 fault, the power needs to 

be disconnected and reconnected to reset the isolation relay before the 
product can be used again. 

The following chart is a quick reference guide on fault codes.  To read a fault 
code off an integrated or flat door model, refer to the LED Display column on 
the chart below.  The LED that has activated on the secondary display 
indicates which fault code has occurred.  
 
To make diagnostics easier, a test handle can be made for use on integrated 

or flat door models using a cut down handle and a DD605 PCB LCD.  This will 
not be able to be used on DD603 products, nor can a DD603 test handle be 
used on DD605 products. 

F1 

Rinse LED.  The bottom 

controller flood 

sensor 
detector has 

been activated 

for more than 
six seconds. 

•  Lid not closing. 

•  Overfilling. 

•  Foaming. 

•  Not draining. 

•  Lid seal damaged. 

•  Dispenser or water softener or 

their seals leaking. 

•  Damaged water inlet or drain 

hoses. 

•  Leaking heater plate or motor 

seals, or drain o-ring seals. 

•  Yoke jammed or broken. 

•  Inlet hose to inlet valve 

connection loose. 

•  Inlet valve body leak. 

•  Heater plate damage (chipped 

enamel). 

•  Dry F1 – PCB mains filter, 

harness or connectors, 
electronic controller.