Binsfeld Engineering Inc TX10K-LP Manual De Usuario
- 19 -
If before activating AutoZero there is an initial offset of more
than 50% of Full Scale, it may be necessary to 1) use a lower
Transmitter Gain setting, 2) apply a shunt resistor to balance
the gage, or 3) replace the strain gage. For further
assistance, contact Binsfeld Engineering Inc.
than 50% of Full Scale, it may be necessary to 1) use a lower
Transmitter Gain setting, 2) apply a shunt resistor to balance
the gage, or 3) replace the strain gage. For further
assistance, contact Binsfeld Engineering Inc.
10. Scroll RX10K display to Filter parameter screen. Set the Filter
to the desired level.
11. Scroll RX10K display to Gain parameter screen. Set the
System Gain to scale and/or calibrate output based on
calculations as demonstrated in Appendix B. Check
calibration by using the RM10K to command the TX10K to
transmit REFERENCE 1 and/or 2 to the RX10K.
calculations as demonstrated in Appendix B. Check
calibration by using the RM10K to command the TX10K to
transmit REFERENCE 1 and/or 2 to the RX10K.
12. Connect appropriate recording device to either the analog
Voltage Output terminals or digital Com (DB9) connector.
Check the zero and adjust using the Output Offset if needed.
Check the zero and adjust using the Output Offset if needed.
13. The system is now ready to record data.
Bench Testing
1. Connect Receiver Antenna to Antenna connector on the rear
panel of the RX10K Receiver. Position magnetic-mount
antenna with element installed near the TX10K.
antenna with element installed near the TX10K.
2. Insert connector on AC/DC adapter into Power Input jack on
the RX10K rear panel. Plug adapter into appropriate AC
power source (i.e., wall socket). Flip the RX10K power switch
to On while holding down the ADJUST
power source (i.e., wall socket). Flip the RX10K power switch
to On while holding down the ADJUST
▲ key.
NOTE: This resets the factory default parameter settings.
Values reported in this section may be different if default
values are not reset.
Values reported in this section may be different if default
values are not reset.
3. Attach 9V Battery Connector to TX10K Transmitter (red to
+PWR, black to –PWR). Attach BS900 Bridge Simulator to
the TX10K terminals +/- EXC and +/- SEN to coincide with
pins on BS900. Clip 9V battery to connector.
the TX10K terminals +/- EXC and +/- SEN to coincide with
pins on BS900. Clip 9V battery to connector.
4. Slowly scroll through each RX10K channel until it matches
TX10K channel setting (top line will quit flashing and bottom
line will show the RF signal strength). Change both units to
line will show the RF signal strength). Change both units to