B+B SmartWorx WLNG551 Manual De Usuario

24

Print

1. Locate a clean, flat surface near the bar code for printing.

2. Place the nose of the SP400X against the surface. The SP400X should rest at an angle of about 7 degrees from vertical.

3. Move the SP400X straight across the surface.

4. When the print is finished, the green light will turn off and the SP400X will emit a Hi tone.

 Maintain a relaxed wrist and hand posture and use low force when printing.

•  Keep the printer wheel continuously in contact with the print surface while printing.

•  Hold the SP400X so that the angle of the device to the surface is approximately 7 degrees.

•  Do not push hard on the surface; light pressure will result in better prints, especially with soft packages.

•  Do not rotate your wrist. Rotating your wrist while printing can cause skipping or incomplete prints.

1. Print wheel

SP400X Series - 5. Operate the SP400X