BEI Electronics LLC 7EPTX-AM5E Manual De Usuario

2-35

WARNING

WARNING

DISCONNECT ALL TRANSMITTER PRIMARY POWER

BEFORE PROCEEDING.

2-150.   Operate the transmitter rear-door ac on/off control switch to OFF.
2-151.

If an audio processor is used with the transmitter, ensure the processor is connected as fol

lows:

1. Ensure normal program audio is connected to the processor input.
2. Ensure the audio processor output is connected to the transmitter audio input.

2-152.   Operate the transmitter rear-door ac on/off control switch to ON.
2-153.

Depress a desired power level switch/indicator to illuminate the switch/indicator.

2-154.

Refer to SECTION III, OPERATION and operate the stereo circuit board mode control

switch to illuminate the stereo indicator.

2-155.

Disable one channel applied to the transmitter.

2-156.

If an audio processor is used with the transmitter, refer to the audio processor manual and

adjust the processor single channel limiter as described in the procedure.

2-157.

Refer to SECTION III, OPERATION and operate the stereo circuit board mode control

switch to illuminate the mono left or mono right indicator as determined by the remaining

operating audio channel applied to the transmitter.

2-158.

Refer to Figure 2-5 and adjust the single channel level control on the exciter circuit board

as required to obtain an approximate 100% modulation indication on the modulation moni

tor.