Cumberland Stove Works MF3800 Manual De Usuario

It is recommended the stove be installed and serviced by 

authorized professionals who are certified by the National

Fireplace Institute (NFI) as NFI Pellet Specialists.
Proper installation of this stove is necessary for safe and 

efficient operation. Installing this product improperly may

result in a house fire and personal injury. All applicable

building  codes  for  your  location  must  be  followed.  In 

areas  where  building  codes  require  additional  steps  to 

the installation of this product not included in this manual, 

the  building  codes  will  take  precedent  and  must  be 

followed.  Contact your local building inspector to obtain 

any  necessary  permits  or  inspection  guidelines  before 

installing the product.

Sketch out a plan for installing the stove including dimensions 

before  permanent  placement.  When  determining  the 

location for the stove, wall stud location is critical. You may 

need to adjust the location of the stove to avoid trying to 

vent through a wall stud. Before placing the parlor stove, 

connect  the  vent  and  allow  for  minimum  clearance  to 

combustible walls. 

The  stove  must  be  installed  on  a  noncombustible  floor,

with proper floor protection, or on a masonry hearth. The

hearth  or  noncombustible  floor  protector  must  extend  a

minimum of 6” in front, and 4” from each side. When a

clean out t-vent is installed in the inside of a home, the

floor protector must extend 2” beyond rear of t-vent. See

figure 12. When stove is vented straight through the wall

and the clean out t-vent is on the exterior of the home, the

minimum clearance is 3” from the back of the stove to the

edge of floor protector. See figure 13. The minimum floor

protector material is 24 gA. sheet metal.

4”

4”

6”

2”

Figure 12

Figure 13

4”

4”

6”

3”