Cumberland Stove Works MF3800 Manual De Usuario

Take  off  protective  cardboard.    Hang  door  on  hinges 

making sure it’s seated properly so latch is aligned with 

latch cut-out.

The door gasket may settle after use and adjustment to 

latch is necessary to ensure proper seal.  To adjust latch 

remove roll pin and swap washers from the inside of door 

to the outside of the door.  Replace roll pin and inspect 

door fit.

The CSW MF Series Stove has three different controller 

mounting options:
1.  Back of the stove with controller visible.You may mount 

the conrollter on either side of the rear of the stove (see

figure 8) so it is visible during operation. To do so use the

metal mounting bracket and the (4) self-tapping screws ((2)

through the plastic bracket and (2) through the back panel

of the stove). Attach through the pre-drilled holes.
note: Self-tapping screws must penetrate hopper.  
2. Back of the stove with controller hidden. You may mount 

the controller on either side of the stove (see figure 9). So it

is not visible during operation.  Attach the plastic mounting 

bracket to the pre-drilled holes on either side of the stove

using the (2) self-tapping screws.
note: Self-tapping screws must penetrate hopper.  
3. Wall mounted (figure 10). You may mount the controller

on the wall next to the unit using two drywall screws. It is

best to embed the screws into a stud. Use a stud finder to

locate studs in the wall.

After mounting the controller plug the phone cord from the 

back of the stove to the underside of the controller.

Figure 8: Controller on metal bracket in back.

Figure 9: Controller on plastic bracket in back.

Figure 10: Controller on wall.

Figure 11: Door Latch Adjustment.