Gossen Metrawatt Metrahit Iso Insulation measuring device, CAT III 600 V Metrahit Iso Manual De Usuario
Los códigos de productos
Metrahit Iso
GMC-I Gossen-Metrawatt GmbH
23
Control Functions
4.5
Measurement Data Recording
The multimeter is capable of recording measurement data using
an adjustable sampling rate for long periods of time in the form of
measurement series. Data are stored to a battery-backed mem-
ory module, and are retained even after the multimeter is switched
off. The system acquires measured values relative to real-time.
an adjustable sampling rate for long periods of time in the form of
measurement series. Data are stored to a battery-backed mem-
ory module, and are retained even after the multimeter is switched
off. The system acquires measured values relative to real-time.
Stored measured values can subsequently be read out with the
help of METRAwin 10 software. The only prerequisite is a PC which
is connected by means of an interface cable to the
USB
help of METRAwin 10 software. The only prerequisite is a PC which
is connected by means of an interface cable to the
USB
⏐
X-
TRA
bidirectional interface adapter, which is plugged onto
a multimeter. See also chapter 7, “Interface Operation”.
Memory Parameters Overview
The STORE Menu Function
➭ First set the sampling rate for memory mode operation (see
➭ First set the sampling rate for memory mode operation (see
rAtE parameter) , and then start memory mode
operation.
➭ First select the desired measuring function and an appropriate
measuring range.
➭ Check the battery charge level before starting long-term
measurement recordings (see chapter 6.3).
Connect the NA
Connect the NA
⏐
X-
TRA
power pack if required.
Starting Recording via Menu Functions
➭ Switch to the “SETUP” mode by pressing MEASURE | SETUP, and
➭ Switch to the “SETUP” mode by pressing MEASURE | SETUP, and
select the “
StorE” menu.
1nFo
Z
...
Z
StorE
000.0 %
Z
StArt
➭ Memory mode operation is started by activating FUNC | ENTER.
STORE
appears underneath the analog display and indicates
that the memory mode has been activated. “
StoP” appears at
the digital display.
➭ Press MEASURE | SETUP in order to return to the measuring
function.
Parameter
Page: Header
CLEAr
EMpty
CLEAr
0CCUP
rAtE
StArt
StoP
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER