Blade 180 QX HD RTF BLH7400 Hoja De Datos

1.  Ensure all trims are centered.
2.  Power on the transmitter and move the throttle stick to full throttle.
3.  Ensure the transmitter is in Stability High or Low Angle Mode.
4.  Hold full up elevator.
5.  Connect the fully charged fl ight battery in the quadcopter.
6.  Both LEDs will fl ash red twice, then blue twice for a few seconds.
7.  When the LED turns solid blue, lower the throttle and return the elevator to center.
8.  Raise the throttle to bring the quadcopter to a hover.
9.  Use the trims on the transmitter to eliminate any drifting, allowing for a stable hover.
10.  While in a stable hover, press and hold the camera trigger on the transmitter for 5 seconds. The quadcopter is now 

calibrating input from the sensors and transmitter.

11.  Release the camera trigger and land the quadcopter. Upon landing, the LEDs should fl ash red then blue. When the 

LEDs repeat with one blink per color, the calibration is complete.

12.  If only the red LED is fl ashing, the calibration has failed. Repeat the process.
13.  Disconnect the battery, then return the trims to center.

Quadcopter control response is 
inconsistent or requires extra trim 
to neutralize movement.

Aircraft not initialized on a level surface.

Disconnect the fl ight battery, center the control 
trim and re-initialize the quadcopter.

Battery not correctly placed in
battery slot.

Adjust battery position so quadcopter balances 
in the center of the frame.

Quadcopter will not respond to 
throttle.

Throttle too high and/or throttle trim is 
too high.

Reset controls with the throttle stick
and throttle trim at the lowest setting.

Quadcopter moved during initialization.

Disconnect the flight battery and re-initialize 
the quadcopter while keeping the quadcopter 
from moving.

Throttle channel is reversed.

Disconnect fl ight battery, reverse the throttle 
channel on the transmitter, 
recconnect fl ight battery.

Quadcopter does not function
and smells burnt after connecting 
the fl ight battery.

Flight battery connected with the wrong 
polarity.

Replace the 5-in-1 board. Connect the fl ight 
battery noting proper polarity.

Quadcopter has reduced fl ight 
time or is underpowered.

Flight battery charge is low.

Completely recharge the fl ight battery.

Inadequate power to fl ight battery charger.

Use a different USB power source for the 
charger.

Flight battery is damaged.

Replace the fl ight battery and follow the fl ight 
battery instructions.

Flight conditions might be too cold.

Make sure the battery is warm (room tempera-
ture) before use.

LED on receiver fl ashes rapidly 
and aircraft will not respond to 
transmitter (during binding).

Transmitter too near aircraft during bind-
ing process.

Power off the transmitter. Move the transmitter 
a larger distance from the aircraft. Disconnect 
and reconnect the fl ight battery to the aircraft. 
Follow the binding instructions. 

Bind switch or button was not held while 
transmitter was powered on.

Power off transmitter and repeat bind process.

Aircraft or transmitter is too close to large 
metal object, wireless source or another 
transmitter.

Move aircraft and transmitter to another
location and attempt binding again.