TP-LINK 24-Port 10/100Mbps + 4-Port Gigabit L2 Managed Switch TL-SL3428 Hoja De Datos

 

10

 

The CLI is divided into different command modes: User EXEC Mode, Privileged EXEC Mode, 

Global Configuration Mode, Interface Configuration Mode and VLAN Configuration Mode. 

Interface Configuration Mode can also be divided into Interface fastEthernet, Interface 

gigabitEthernet, Interface link-aggregation and some other modes, which is shown as the following 

diagram. 

 

The following table gives detailed information about the Accessing path, Prompt of each mode and 

how to exit the current mode and access the next mode. 

User EXEC 
Mode 

Primary mode once it is 
connected with the 
switch. 

Use the exit command to disconnect the 
switch (except that the switch is 
connected through the Console port). 

Use the enable command to access 
Privileged EXEC mode. 

Privileged 
EXEC Mode 

Use the enable 
command to enter this 
mode from User EXEC 
mode. 

TL-SL3428 # 

Enter the disable or the exit command to 
return to User EXEC mode. 

Enter  configure command to access 
Global Configuration mode. 

Global 
Configuration 
Mode 

Use the configure 
command to enter this 
mode from Privileged 
EXEC mode. 

TL-SL3428(config)# 

Use the exit  or the end command or 
press  Ctrl+Z to return to Privileged 
EXEC mode. 

Use the interface 

fastEthernet/ 

gigabitEthernet port or interface range 
fastEthernet/gigabitEthernet 

port-list 

command to access interface 
Configuration mode. 

Use the vlan  vlan-list to access VLAN 
Configuration mode. 

Interface 
Configuration 
Mode 

Use the interface 
fastEthernet/gigabitEth
ernet  port or interface 
range fastEthernet/ 
gigabitEthernet  port-list 
command to enter this 
mode from Global 
Configuration mode. 

range)# 

Use the end command or press Ctrl+Z to 
return to Privileged EXEC mode. 

Enter  exit  or # command to return to 
Global Configuration mode. 

A port number must be specified in the 
interface command.