TP-LINK 24-Port 10/100Mbps + 4-Port Gigabit L2 Managed Switch TL-SL3428 Hoja De Datos

 

For the member ports in an aggregation group, their basic configuration must be the same. The 

basic configuration includes STP, QoS, GVRP, VLAN, port attributes, MAC Address Learning 

mode and other associated settings. The further explains are following: 



 

If the ports, which are enabled for the GVRP, 802.1Q VLAN, Voice VLAN, STP, QoS, Port 

Isolation,    DHCP Snooping and Port Configuration (Speed and Flow Control), are in a 

LAG, their configurations should be the same. 



 

The ports, which are enabled for the Port Security, Port Mirror, MAC Address Filtering, 

Static MAC Address Binding, Half-Duplex and 802.1X Authentication, can not be added 

to the LAG. 



 

It’s not suggested to add the ports with ARP Inspection and DoS Defend enabled to the 

LAG. 

If the LAG is needed, you are suggested to configure the LAG function here before configuring the 

other functions for the member ports. 

1.  Calculate the bandwidth for a LAG: If a LAG consists of the four ports in the speed of 

1000Mbps Full Duplex, the theoretical maximum bandwidth of the LAG is up to 8000Mbps 
(2000Mbps * 4) because the bandwidth of each member port is 2000Mbps counting the 
up-linked speed of 1000Mbps and the down-linked speed of 1000Mbps. 

2.  The traffic load of the LAG will be balanced among the ports according to the Aggregate 

Arithmetic. If the connections of one or several ports are broken, the traffic of these ports will 
be transmitted on the normal ports, so as to guarantee the connection reliability.   

Depending on different aggregation modes, aggregation groups fall into two types: Static LAG 

and LACP Config. The LAG function is implemented on the LAG Table, Static LAG and LACP 

Config configuration pages. 

On this page, you can view the information of the current LAG of the switch. 

Choose the menu Switching→LAG→LAG Table to load the following page. 

39