Hughes DIRECWAY DW4020 Manual De Usuario
Chapter 2 • Installing the indoor equipment
1031484-0001 Revision 2
17
Connect Ethernet,
power up, and read the
Gateway LED display
power up, and read the
Gateway LED display
After you assemble the DW4020, connect it to the installer laptop
with Ethernet cable. Plug it into a 110 V wall outlet, power strip,
or surge protector. The Gateway LED display will cycle. The
cycle completes in less than a minute and follows this sequence:
with Ethernet cable. Plug it into a 110 V wall outlet, power strip,
or surge protector. The Gateway LED display will cycle. The
cycle completes in less than a minute and follows this sequence:
• Gateway STATUS LED is red until the power-on self-tests
are completed.
• Gateway READY LED blinks green because it is not yet
commissioned.
• Gateway STATUS LED blinks orange as it is not attached to
the receive modem.
Figure 12: Connect power cord
Transmit
modem
Ethernet port
Receive
modem
Gateway
Ethernet cable
USB cable
AC power
cord
DC power
cord
Power
supply
Installer laptop PC
Note:
In countries outside North America, the DW4020 may be
plugged, with a physical adapter, directly into a 220 V outlet.
Different countries may have different standards and requirements.
Different countries may have different standards and requirements.
Note:
Whenever the LEDs do not function properly as described
below, check to be sure you have the correct power supply, PN
1031105-0001.
1031105-0001.