Hughes DIRECWAY DW4020 Manual Do Utilizador

After you assemble the DW4020, connect it to the installer laptop 
with Ethernet cable. Plug it into a 110 V wall outlet, power strip, 
or surge protector. The Gateway LED display will cycle. The 
cycle completes in less than a minute and follows this sequence:

• Gateway STATUS LED is red until the power-on self-tests 

are completed.

• Gateway READY LED blinks green because it is not yet 

commissioned.

• Gateway STATUS LED blinks orange as it is not attached to 

the receive modem.

Figure 12: Connect power cord

Transmit

modem

Ethernet port

Receive

modem

Gateway

Ethernet cable

USB cable

AC power

cord

DC power

cord

Power

supply

Installer laptop PC

Note:

In countries outside North America, the DW4020 may be 

plugged, with a physical adapter, directly into a 220 V outlet. 
Different countries may have different standards and requirements. 

Note:

Whenever the LEDs do not function properly as described 

below, check to be sure you have the correct power supply, PN 
1031105-0001.