Cabletron Systems CSMIM-T1 Manual De Usuario

From the CSMIM-T1 console port:

At the monitor prompt, enter console-baud.

At the Select baud rate prompt, enter the appropriate baud rate or 
auto.

Connect the modem to the CSMIM-T1’s console port.

From the remote site:

Dial into the modem connected to the CSMIM-T1.

Type 

RETURN

 until the monitor prompt appears.

The erase command erases the contents of non-volatile memory, 
including the CSMIM-T1’s IP address. This command also restores the 
parameters to their factory defaults. The syntax is:

If the self-boot option is installed, the erase command prompts for which 
non-volatile memory to erase: EEPROM or FLASH. Entering 1 at the 
prompt causes the CSMIM-T1 to erase the EEPROM memory 
(configuration information); entering 2 at the prompt causes the 
CSMIM-T1 to erase the Flash memory (self-boot image). 

The erase command display looks like this:

monitor:: erase
  1) EEPROM (i.e. configuration information)
  2) FLASH (i.e. self boot image)
Enter 1 or 2 :: 1
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <16352 or 8160 bytes> of non-volatile memory.
Please wait . . . 
                                            16K->|Data 0xff
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
                                            16K->|Data 0x0
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initialized checksum record installed
.
.
.