Bay Technical Associates 350 Manual De Usuario
Using the BayStack 350 10/100 Autosense Switch
3-54
893-00992-B
Reset to Default Settings
The Reset to Default Settings command allows you to reset the switch and replace
all configured switch parameters with the factory default settings. For a list of
factory default settings, refer to Appendix C, “Switch Default Settings.”
all configured switch parameters with the factory default settings. For a list of
factory default settings, refer to Appendix C, “Switch Default Settings.”
The Reset to Default command takes approximately five seconds to complete.
During this time, the switch initiates a self-test that comprises various diagnostic
routines and subtests. The results of the self-test are displayed briefly in the
BayStack 350 switch Self-Test screen (Figure 3-27), which is followed by the CI
screens.
During this time, the switch initiates a self-test that comprises various diagnostic
routines and subtests. The results of the self-test are displayed briefly in the
BayStack 350 switch Self-Test screen (Figure 3-27), which is followed by the CI
screens.
Figure 3-27.
Self-Test screen after resetting the switch to default settings
The switch LEDs also display various patterns to indicate that the subtests are in
progress.
progress.
Caution:
If you choose this command, all of your configured settings will be
replaced with factory default settings when you press [Enter].
Note:
The Self-Test screen remains displayed only if the self-test detects a
fatal error.
BayStack Model 350T Self-Test
ASIC addressing test ... Pass
ASIC buffer RAM test ... Pass
Physical layer test ... Pass
Port internal loopback test ... Pass
Self-test complete.
350fbk.book Page 54 Wednesday, July 9, 1997 4:51 PM