Whirlpool G7CG3064X Instruccion De Instalación

INSTALLATION INSTRUCTIONS

Install Cooktop

Decide on the final location for the cooktop. Avoid drilling into or
severing existing wiring during installation.

1. Determine whether your cabinet construction provides

clearance for installing clamping brackets at cooktop base
ends. This is the recommended location. Clamping brackets
can be installed on the front and back of cooktop base
bottom, if necessary.

2. Using 2 or more people, place cooktop right side up into the

cutout.

NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.

3. Remove the attachment screws for the selected bracket

locations from the bottom of the cooktop base.

4. Attach brackets to cooktop base bottom with bracket

attachment screws. Securely tighten screws.

NOTE: There will be a small gap (approximately

¹⁄₈" [3 mm])

between the cooktop and the countertop. This is normal. See
the following illustration.

A. Attachment screw holes for optional front and back location
B. Cooktop base bottom

C. Attachment screw
D. Clamping bracket (end locations recommended)

A. Edge of cooktop base bottom
B. Clamping bracket

WARNING

Excessive Weight Hazard

Use two or more people to move and install cooktop.

Failure to do so can result in back or other injury.

A. Cooktop
B. Cooktop base

C. 2" (5.1 cm) bracket attachment screw
D. Clamping bracket (extends far enough beyond cooktop

base to allow installation of clamping screws)

E. Countertop

A. Small gap (approximately

¹⁄₈

" [3 mm])

between cooktop and countertop