Инструкции По Установке для Whirlpool G7CG3064X
8
INSTALLATION INSTRUCTIONS
Install Cooktop
Decide on the final location for the cooktop. Avoid drilling into or
severing existing wiring during installation.
severing existing wiring during installation.
1. Determine whether your cabinet construction provides
clearance for installing clamping brackets at cooktop base
ends. This is the recommended location. Clamping brackets
can be installed on the front and back of cooktop base
bottom, if necessary.
ends. This is the recommended location. Clamping brackets
can be installed on the front and back of cooktop base
bottom, if necessary.
2. Using 2 or more people, place cooktop right side up into the
cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.
3. Remove the attachment screws for the selected bracket
locations from the bottom of the cooktop base.
4. Attach brackets to cooktop base bottom with bracket
attachment screws. Securely tighten screws.
NOTE: There will be a small gap (approximately
¹⁄₈" [3 mm])
between the cooktop and the countertop. This is normal. See
the following illustration.
the following illustration.
A. Attachment screw holes for optional front and back location
B. Cooktop base bottom
B. Cooktop base bottom
C. Attachment screw
D. Clamping bracket (end locations recommended)
D. Clamping bracket (end locations recommended)
A. Edge of cooktop base bottom
B. Clamping bracket
B. Clamping bracket
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
B
C
C
D
A
A
B
A. Cooktop
B. Cooktop base
B. Cooktop base
C. 2" (5.1 cm) bracket attachment screw
D. Clamping bracket (extends far enough beyond cooktop
D. Clamping bracket (extends far enough beyond cooktop
base to allow installation of clamping screws)
E. Countertop
A. Small gap (approximately
¹⁄₈
" [3 mm])
between cooktop and countertop
A
B
C
D
E
A