Dacor DYWS4 Guía De Referencia

Page 2

STEP 4   Open the door on the front of the 

system. Swing the spout cover to the 

up position.

STEP 5   Make sure the power switch, located 

on the left side of the bottle bay, is 

slid all the way down, to the 

OFF 

position.

STEP 6   Find the gas regulator assembly 

that comes with the system. Make 

sure the regulator adjustment knob 

is turned all the way in the 

OFF 

direction.

STEP 7   Connect the gas supply line from 

the wine dispensing system to the 

gas connector on the regulator as-

sembly.

STEP 8   Remove the plastic cap from the 

top of the argon gas cylinder.*

STEP 9   Insert the top of the gas cylinder 

into the bottom of the gas regula-

tor assembly and turn it clockwise, 

by hand, until it is snug. Do not 

use a wrench or overtighten.

STEP 10   Turn the regulator knob in the ON 

direction until it stops.

Regulator 

adjustment 

knob

Gas supply 

line from wine 

dispensing 

system

Regulator 

assembly

Argon 

gas  

cylinder

ON 

SERVICE MODE 

RESERVED 

OFF

Spout cover

STEP 11   Plug the power cord into the grounded 120 Vac., 60 Hz. electrical outlet.
STEP 12   Slide the power switch all the way up to the ON position. When powering on, the sys-

tem will run through a series of diagnostics, which will take several seconds. If the 

control panel is locked, perform the following steps:
•  Slide the power switch down one notch to the 

SERVICE MODE position (see dia-

gram at top of page).

•  Push 

WineStation Service next to any of the displays.

•  Push 

Exit.

•  Slide the power switch up to the 

ON position.

*IMPORTANT: The required argon 

gas cylinder is not shipped with 

the system and must be ordered 

separately. Order on-line at www.

everythingdacor.com or by calling 

Dacor Customer Service at (800) 

793-0093 ex. 2822. Your first gas 

argon gas cylinder is provided free 

of charge.