Dacor DYWS4 Guía De Referencia

Page 3

STEP 13  Open a wine bottle and place it on a flat, dry

surface.

STEP 14  Insert the included head selection tool into 

the bottleneck to determine the correct (color 

coded) gasket size.

STEP 20   Carefully insert the dispensing head (with the 

pick up tube still attached) into the bottle.

STEP 21   While pressing down on the head with one 

hand, tighten the collar with your other hand. 

Use only two fingers and your thumb to turn.

The gasket will expand inside the bottleneck, 

sealing and holding the bottle from the inside. 

Do not over-tighten.

STEP 22   While holding the head and bottle over a 

table or countertop for safety, grasp the top of 

the head without touching the bottle. Lift the 

head up 2 inches and shake slightly to check 

that the bottle is snuggly attached. If the 

bottle comes loose, retighten the head.

Green

Red

White

Insert 

pick-up 

tube 

STEP 15  If you do not have a dispensing head with the 

correct color gasket installed:
•  Remove the gasket nut on the bottom of 

the head by turning it counter-clockwise. 

•  Replace the gasket with the correct color 

and replace the gasket nut.

STEP 16   Insert a clean pick up tube into the bottle. (It 

is normal for the upper end of the tube to ex-

tend beyond the tip of the bottle at this point).

STEP 17   Insert the pick up tube firmly into the opening

on the bottom of the head.

STEP 19   Fully un-tightened the head collar until it 

stops.

Gasket

Dispensing 

head

Gasket 

nut