HP (Hewlett-Packard) 760c Manual De Usuario
62
Maintaining the Projector
Replacing the Lamp and Air Filter
The life span of the projection lamp is about 2000 hours if
Brightness
Control
in the Setting menu is set to
High
(default), and
3000 hours if
Brightness
Control
is set to
Low
.
It is time to replace the lamp when:
■
The projected image gets darker or starts to deteriorate.
■
The message
Replace the lamp
appears on the screen when the
lamp comes on and the lamp warning light
flashes orange. To
maintain projector brightness and image quality, replace the lamp
as soon as possible.
as soon as possible.
■
The lamp warning light
flashes red (the lamp is burnt out).
Contact your dealer or call Epson at 800-GO-EPSON
(800-873-7766). Request part number V13H010L32.
(800-873-7766). Request part number V13H010L32.
Follow these steps to replace the lamp and air filter:
1. Turn off the projector.
2. When the
Power
light stops flashing, unplug the power cord.
3. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
note
When you get a replacement
lamp for your projector, you
should replace the filters.
lamp for your projector, you
should replace the filters.
To check how long the lamp
has been in use, see page 71.
has been in use, see page 71.
warning
Let the lamp cool fully
before replacing it.
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
Montreal User's Guide.book Page 62 Tuesday, April 19, 2005 11:27 AM