Mitsumi electronic MR-J3- A Manual De Usuario
6 - 3
6. DISPLAY AND OPERATION SECTIONS
6.3 Status display
The servo status during operation is shown on the 5-digit, 7-segment LED display. Press the "UP" or "DOWN"
button to change display data as desired. When the required data is selected, the corresponding symbol
appears. Press the "SET" button to display its data. At only power-on, however, data appears after the symbol
of the status display selected in parameter No.PC36 has been shown for 2[s].
The servo amplifier display shows the lower five digits of 16 data items such as the motor speed.
6.3.1 Display transition
button to change display data as desired. When the required data is selected, the corresponding symbol
appears. Press the "SET" button to display its data. At only power-on, however, data appears after the symbol
of the status display selected in parameter No.PC36 has been shown for 2[s].
The servo amplifier display shows the lower five digits of 16 data items such as the motor speed.
6.3.1 Display transition
After choosing the status display mode with the "MODE" button, pressing the "UP" or "DOWN" button changes
the display as shown below.
the display as shown below.
DOWN
Regenerative load ratio
Effective load ratio
Peak load ratio
Instantaneous torque
Cumulative feedback
pulse
pulse
Within one-revolution position
(1 pulse unit)
(1 pulse unit)
Servo motor speed
Within one-revolution position
(100 pulse unit)
(100 pulse unit)
Droop pulse
ABS counter
Cumulative command
pulse
pulse
Load inertia moment ratio
Command pulse
frequency
frequency
Bus voltage
UP
To Bus voltage
To Cumulative feedback pulse
Analog speed command
voltage
Analog speed limit voltage
voltage
Analog speed limit voltage
Analog torque command
voltage
Analog torque limit voltage
voltage
Analog torque limit voltage