Perlick BBSN Manual De Usuario

Models BBRN/BBSN Installation & Operation Manual

Printed in USA

0213

InsTallaTIon

General Information

• For units equipped with a power cord, the

cord and plug may be aligned with a recess in

the back panel to allow the unit to be pushed

closer to the wall. For correct alignment, the

wall outlet must be located 4” - 10” above the

floor.

• Floor must be level in area of installation.

Preparing the Space

CAUTION

Make sure the floor under

the unit is level with the

surrounding finished floor. Protect a finished

floor with plywood, cardboard or some other

suitable material before moving the unit into

place. Failure to do this may result in damage

to the floor.
NOTE: If unit has been laid on its back or sides,

place unit upright and allow minimum of 24 hours

before connecting to a power source. Failure to

follow this procedure may damage the compressor

and void warranty.
1. Make sure the space opening is correctly

sized for the unit. See Dimension drawings at

the back of this manual for correct dimensions.

NOTE: For a cabinet door to open properly, the

door must open a minimum of 90°. Use a minimum

3” filler in corner installations to assure a 90°

opening. Allow 24” clearance in front of the unit

for full door swing and shelf/drawer pull-out.
2. Check that the following are level and square:

• Front and interior opening
• Installation opening and floor surface

NOTE: The floor under the unit must be at the

same level as the surrounding finished floor.

Casters or Legs

Refer to the instructions included with the Casters

or Legs Kit.

Installing the Unit

CAUTION

If unit has been laid on its

back or sides, place unit

upright and allow minimum of 24 hours before

connecting power.
1. With power applied to the unit, check that

the lighting and cooling functions operate

properly, then turn off power to the wall outlet

and/or circuit breaker.

2. Position the cabinet into place using rollers

when necessary.

NOTE: Proper air flow around the condensing unit

is necessary for efficient operation. Never obstruct

the air flow in and out of the condensing unit.
3. When cabinet is in place, check installation

with carpenter’s level. When the unit is level

front-to-back and side-to-side, accumulated

water will drain out of cabinet to evaporator

drain.

4. Turn on power to the outlet and/or circuit

breaker.

Electric Condensate Evapaway

(Optional)

For installation in areas of high humidity, a 115-

volt electric condensate pan can be installed

underneath the cabinet to collect and evaporate

the condensate from the cabinet evaporator. A 6’

3-prong plug is included. A separate circuit should

be provided for the heater. The kit can be used

only on cabinets equipped with 4” minimum legs;

it cannot be used on units equipped with platform

or base plate kits. Follow instructions supplied

with the kit.

Base Plate Installation (Optional)

Once the unit is secured in place, install the base

plate brackets to the cabinet bottom in the holes

provided. Attach base plate to brackets. Refer

to the installation instructions included with the

Base Plate Kit.