Perlick BBSN Manual De Usuario
Models BBRN/BBSN Installation & Operation Manual
Printed in USA
6
0213
Digital Temperature Control
SET
F
C
Figure 2. Digital Temperature Controller
To change the Setpoint:
1. Press the SET button for more than 2 seconds.
2. The value of the setpoint will be displayed and
1. Press the SET button for more than 2 seconds.
2. The value of the setpoint will be displayed and
the “C” or “F” LED starts blinking.
3. To change the Set value, press the
or
button within 10 seconds.
4. To memorize the new setpoint value, press
the SET key again, or wait 10 seconds.
adjusTmenTs
Changing Door Swing Direction
NOTE: Changing the door swing direction is
not advisable if the door is not equipped with
a full length handle. Doing so may result in an
undesirable handle position..
Hinge Kits
Part No. 67439R: Right Hinging
Part No. 67439L: Left Hinging
Part No. 67439L: Left Hinging
Tools Required
• Large flat head screwdriver
• Regular Phillips head screwdriver
• Hinge Kit from Perlick
• Plastic putty knife
• Regular Phillips head screwdriver
• Hinge Kit from Perlick
• Plastic putty knife
Procedure
SUPPORT
Pull door to
the side then lower door
Remove hinge pin
Figure 3. Door Removal
1. Support the door in the open position as
2. Pull door to the side and then lower the door.
3. Remove top and bottom hinge brackets.
3. Remove top and bottom hinge brackets.
4. Remove the hole plugs from the top and
bottom hinge bracket mounting holes (Figure
4). Place the plugs in the holes on the opposite
side made vacant by removing the hinges in
step 3.
Hinge brackets
and mounting
screws
Hinge brackets
and mounting
screws
Hole plugs
Figure 4. Hinge Removal