Bakers Pride NMK Manual De Usuario
6
EXTRACTION
Extraction is not a specific requirement for this type of appliance.
Certain conditions e.g.
Certain conditions e.g.
Installation in a confined space, temperature controlled environment,
continuous use or high volume production cooking may require the need for
ventilation
or
extraction.
Consult your local Ventilation/Extraction, Air conditioning company or contact the
Technical Services Department at BKI.
ELECTRICAL CONNECTION
This appliance requires a 230V,50Hz single phase + Neutral + Earth power
Supply.
Supply.
•
Each appliance is despatched with an electrical test certificate.
•
Check the details shown on the appliance data rating plate against the cer-
tificate supplied.
tificate supplied.
•
Check that the voltage shown on the data plate and test certificate con-
forms with your power supply.
forms with your power supply.
If the details do not conform contact the Technical Services Department at BKI
BKI Europe
Theale Technology Centre
Station Road
Theale
Reading
West Berkshire
RG7 4AA
Tel: (44) 0870 990 4242
Fax: (44) 0870 990 4243
Web: www.bkideas.com
WARNING - THIS APPLIANCE MUST BE EARTHED
11
Safety Cut-Out - Re-Set Button
If the safety thermal cut-out operates, first check that the oven has been installed
properly and is operated and cleaned in accordance with the installation and oper-
ating instructions.
properly and is operated and cleaned in accordance with the installation and oper-
ating instructions.
•
Turn the mains switch `OFF`, disconnect oven from mains power supply.
•
Refer to the relevant wiring diagram and check all components and con-
trols before re-setting the safety thermal cut-out.
trols before re-setting the safety thermal cut-out.
•
The safety thermal cut-out is located within the oven control panel compart-
ment. Reset the thermal cut-out as follows:-
ment. Reset the thermal cut-out as follows:-
1.
Remove the two side panel securing screws, slide the panel `Up` and `Out`
at the bottom.
at the bottom.
2.
The safety thermal cut-out is sited towards the top left of the component
plate.
plate.
3.
Press hard on the `Red` re-set button on top of the thermal cut-out (allow
time for the oven to cool down).
time for the oven to cool down).
4.
Replace side panel and check oven operation.
WARNING:
REPEATED OPERATION OF THE SAFETY THERMAL CUT-OUT IS A CLEAR
INDICTAION OF COMPONENT FAILURE OR MISUSE.
SERIOUS DAMAGE WILL OCCUR IF THE CAUSE IS NOT IDENTIFIED AND
RECTIFIED.