Cognitive Solutions Advantage RFID Thermal Printer Manual De Usuario

   

P R O G R A M M I N G  

If the printer will not print this label but does print labels that were 

prepared on another system, your system may not be compatible with 
the printer. The most common cause of this is improper end-of-line 

termination. 

NOTE: Hex dump mode allows you to see every character that reaches the 
printer. Use of hex dump mode can help resolve some programming problems. 

When a particular label format will not print or is cut off at the bottom, 

the trouble is frequently in the header line. Check the header line before 
continuing. Especially check that the header line begins with the proper 

mode character and specifies the correct number of dot rows. When 

programming portable printers, the header line should be preceded by 
the wake-up string. 

You can usually isolate a bad printer command by placing a "C" before 

selected command lines. Begin by commenting out the most complex 

lines, then try printing the format again. If the problem persists, try 
commenting out every line between the header line and the END 

statement, then add lines one at a time to see which lines are at fault. 

After you have isolated the portion of the format that does not work, 

examine the code for errors or test the code by itself in a simpler format. 
When examining label formats, look for instances where the letters "O" 

or "I" have been incorrectly entered for the numbers 0 and 1. These are 

very common typographical errors. 

Common Issues 

The following issues are based on technical support records of user 

questions. 

Label skipping can frequently be corrected by performing a printer 

calibration. Refer to 

 for the 

calibration procedure. 

Copyright © 2004, Cognitive. 

67