Cognitive Solutions Advantage RFID Thermal Printer Manual De Usuario

P R O G R A M M I N G

READY Light is Red

Make sure that the printhead is latched down tightly on both sides.

If the printer feeds out multiple blank labels, it will need to be

calibrated. Refer to

calibration instructions.

Make sure that you have the correct power supply for your printer.

Blaster and Advantage model printers use a 19VAC output power
supply; Del Sol and Solus model printers have a 24VAC output power

supply. The output voltage is printed on the power supply.

Setting Up an Ethernet Printer

First, connect the printer to a PC via the parallel or serial port (see

parallel or serial port setup). Do NOT connect the Ethernet cable at this
time.

Type in the following commands from a Dos Editor or from Notepad on
your computer:

! 0 0 0 0 (Must use zero; space between each character)

VARIABLE ETHERNET IP xxx,xxx,xxx,xxx

VARIABLE NETMASK xxx,xxx,xxx,xxx

VARIABLE GATEWAY xxx,xxx,xxx,xxx

VARIABLE ETHERNET RESET

END

Send this file to the printer by going to File->Print. The printer will not

print anything, but the ready light will blink off and on. When you have
a solid Green ready light, cycle the power on the printer.

NOTE: If using a Unix/Linux system, you will need to create a text file in an
editor, then print or copy the file to the printer.

Next, disconnect the parallel or serial cable and connect the Ethernet.

You should now be able to ping the printer.

NOTE: The parallel or serial cable and the Ethernet cable should NOT be
connected to the printer at the same time.