Cabletron Systems 3Com Manual De Usuario

The AP can be mounted in any number of locations, some of which are shown 
below.

To mount an AP on a flat surface, place the AP so that it rests on the four rubber 
pads on its underside. The surface should be clear of debris and away from traffic. 

To mount an AP on a wall:

1 Attach the mounting bracket to the AP by lining up the raised flanges in the 

center of the bracket with the mounting holes on the bottom of the AP. 

2 Firmly press the rounded ends of the flanges into both mounting holes, and then 

push forward until the flanges slide into the holes and the bracket locks into place.

3 Mount the AP, using two screws (not provided) inserted into the wall through the 

holes on the outer flanges of the mounting bracket.

Or:

1 Using the mounting bracket (shown below) as a template, mark the location of 

the two flanged holes in the center of the bracket on the wall with a pen or pencil.

2 Install two screws at the marks on the wall made in Step 1. Leave the heads of the 

screws approximately 1/8” above the surface of the wall.

3 Position the AP on the wall, and slide it down so that it hangs from the two screws 

installed in Step 2.