Crown Audio I-T5000 HD Manuel D’Utilisation

“Off/Flashing/On” means that the 
LED can be off, or fl ashing, or on.

CONDITION: Power indicator is 
off and power switch is not illu-
minated.

•  The amplifi er has lost AC power.

•  The amplifi er is not plugged into the 

power receptacle.

•  Rear-panel breaker is off.

CONDITION: Power indicator 
is off and power switch is illu-
minated.

•  The amplifi er’s power switch is off.

•  The AC line voltage has dropped below 

15% or has risen above 15% of the 
rated range.

•  The amplifi er is becoming too hot for safe 

operation. Allow amplifi er to cool. Check for 
loads less than 2 ohms, and for excessive 
input levels. Check for proper ventilation.

•  The amplifi er channel has stopped 

operating. Refer the unit to an authorized 
Crown Service Center.

CONDITION: Power indicator is 
off and power switch is not illu-
minated.

•  Load is wired incorrectly or Output Mode 

switch in LCD-screen menu is set incor-
rectly. Check both.

•  Input is overloaded by a signal level that 

is too high. Turn down your amplifi er level 
controls (Encoders), or turn down the 
input signal, until the clip light goes out.

Note: If the signal sounds distorted even 
though the Clip LED is off, the input signal 
may be distorted before it reaches the 
amplifi er input. Check gain staging and 
output levels of the mixer or preamp.