ARRI 416 Manuel D’Utilisation

•  Move the magazine release lever safety catch to the 

open position 

a

. 

•  Press down the magazine release lever 

a

 and 

remove the magazine opening cover.

•  Remove the loop protector from the magazine.

•  Place the magazine’s throat in the camera opening and 

slide the magazine forward into the camera until it latches.

•  Flip the magazine release lever safety catch forward to 

prevent accidental release of the magazine.

•  Press the “PHASE” button for a couple of seconds to 

inch the film.

Note: 

After a new magazine has been attached or after 

camera power has been turned on, you should 

always push the “PHASE” button to perform a loop 

check (the display shows “LooP“). This takes about 

2 seconds and will engage the pull down claw, 

check loop size and centre the loop properly.

Note: 

If the loop check finds that the loop is too short for 

safe camera performance the message “Error 

LooP.S“ will show in the camera display. The camera 

is not ready and will not run. If the loop check 

finds that the loop is too long for safe camera 

performance the message “Error LooP.L“ will show 

in the camera display. The camera is not ready 

and will not run. 

release lever

release lever 

safety catch