ARRI 416 Manuel D’Utilisation
Shifting phase
After the camera has run up, the frame rate can be
temporarily increased by 0.2 fps while the button the
“PHASE” is held pressed
a
photo
. This is normally used
when synchronizing to an interlaced video signal – look
through the viewfinder and hold the “PHASE“ button
pressed until the bar in the video picture is no longer visible
on the monitor. Always confirm results with a film test.
Displaying Power Supply Voltage (Mode 3)
Camera
Operation
RUN button
PHASE button
• Change from Mode 1 to Mode 3 by pressing the
“MODE” button twice. The power supply voltage is
shown in the lower line of the display.
Note:
If the camera has an OBB-2 attached, the
options of battery capacity (in percent) or
remaining magazines can be displayed instead
of voltage.