Hunter Fan TYPE 2 Manuel D’Utilisation

C 1989 HUNTER FAN COMPANY

REV: 5/94

5. RE-ADJUST 3 GLOBE MOUNTING SCREWS.

5, GLOBE IS VIBRATING AND EMITTING NOISE.

1. USE BALANCING KIT (SEE STEP 8C).
2. LOWER OR MOVE FAN.
3. TIGHTEN ALL SCREWS.
4. TURN POWER OFF, SUPPORT FAN VERY CAREFULLY,

LOOSEN CANOPY AND HANG CORRECTLY.

4. CHANGE TO APPROVED SPEED CONTROL.

3. REPLACE ENTIRE SET OF BLADES.

2. TIGHTEN SCREWS.

1. TIGHTEN SCREWS UNTIL SNUG.

4. PULL SWITCH CHAIN.

3. PUSH SWITCH FIRMLY TO ONE SIDE OR THE OTHER.

POWER OFF WHILE CHECKING).

2. LOOSEN CANOPY, CHECK ALL CONNECTIONS (TURN

1. TURN POWER ON OR REPLACE FUSE.

SOLUTION

1. UNBALANCED BLADES.
2. FAN TOO CLOSE TO VAULTED CEILING.
3. LOOSE BLADES OR BLADE BRACKETS.
4. FAN NOT SECURE ON HANGER ASSEMBLY.

4. NON-APPROVED SPEED CONTROL BEING USED.

3. BLADE CRACKED.

2. BLADE SCREWED LOOSELY TO BLADE BRACKET.

1. BLADE BRACKETS LOOSELY SCREWED TO MOTOR.

4. PULL CHAIN SWITCH NOT "ON".

3. MOTOR REVERSING SWITCH NOT ENGAGED.

WRONG CONNECTIONS.

2. LOOSE WIRE CONNECTIONS OR

1. POWER TURNED OFF OR FUSE BLOWN.

PROBABLE CAUSE

SPEED, WOBBLE WILL DISAPPEAR. IF YOU HAVE CHECKED THE ABOVE PROBLEMS AND STILL HAVE TROUBLE, CALL (901) 745-9222.

WHEN SWITCHING FROM MEDIUM TO LOW SPEED, YOU MAY NOTICE SOME FAN WOBBLE. WHEN FAN SPEED STABILIZES AT LOW

3. EXCESSIVE WOBBLING.

2. NOISY OPERATION.

*NOTE: IF BLADES WILL NOT TURN BY HAND, CONTACT YOUR NEAREST SERVICE REPRESENTATIVE.

FAN DOES NOT MOVE.

1. NOTHING HAPPENS

PROBLEM

TROUBLESHOOTING GUIDE

FORM NO. 40987-01

PAGE 5

AS AN OPTION, A WALL MOUNTED SPEED CONTROL SWITCH IS AVAILABLE FROM YOUR HUNTER DEALER.

SPEED CONTROL

EXTENSION PIPES ARE AVAILABLE AT YOUR HUNTER DEALER AND MAY BE ADAPTED TO FIT YOUR FAN.

IF YOUR CEILING IS HIGHER THAN EIGHT FEET, YOU MAY ELECT TO USE A LONGER HANGER PIPE.

EXTENSION PIPES

SWITCH TO THE OPPOSITE POSITION AND SWITCH FAN BACK ON. SEE FIGURE 9.

FLOW. IF YOU WISH TO CHANGE DIRECTION, SWITCH FAN OFF AND ALLOW TO STOP. SLIDE REVERSING

C. MOTOR IS ELECTRICALLY REVERSIBLE. WHEN FIRST OPERATING FAN, DETERMINE DIRECTION OF AIR

SIMPLY REINSERT THE CONNECTOR. IT CAN BE USED AGAIN AND AGAIN. SEE FIGURE 9.

TO SEPARATE FROM THE CHAIN AT A PREDETERMINED FORCE. IF THIS SEPARATION OCCURS,

POSSIBLY RESULTING IN DAMAGE TO BLADES OR PULL CHAIN. THE BREAKAWAY CONNECTOR IS DESIGNED

ALSO, RELEASE THE CHAIN SLOWLY SO AS TO PREVENT CHAIN FROM FLYING UP INTO BLADES,

B. SWITCH OPERATES IN THIS SEQUENCE: "HIGH," "MEDIUM," "LOW," "OFF." PULL CHAIN SLOWLY TO OPERATE.

A. TURN ELECTRICAL SERVICE ON AT MAIN PANEL.

OPERATION OF FAN

STEP 10:

MEMPHIS, TN 38114

2500 FRISCO AVENUE

HUNTER FAN COMPANY

SINCE 1886