Hunter Fan TYPE 2 Manuel D’Utilisation

REV: 5/94

FIGURE 7.

CANOPY

CEILING PLATE

MOUNTING SCREW (3)

MOUNTING SLOTS (3)

SEE FIGURE 7A.

MAKE CERTAIN GROOVE AND TAB ARE ENGAGED BEFORE RUNNING FAN.

FAILURE TO DO THIS COULD RESULT IN THE FAN FALLING.

IN CANOPY.

FOR THE HANGING FAN CONFIGURATION, ROTATE FAN UNTIL GROOVE IN BALL IS POSITIONED OVER TAB

NOTE:

--FOR HANGING FAN CONFIGURATION--

SECURELY)

BALL

FIGURE 5B.

FIGURE 5A.

PLATE HOOK

FORM NO. 40987-01

PAGE 3

NOTE:

STEP 6:

CAUTION:

THE SPLICES SHOULD BE TURNED UPWARD AND PUSHED CAREFULLY UP INTO THE OUTLET BOX.

OTHER SIDE OF THE BOX.

GREEN WIRES ON ONE SIDE OF THE OUTLET BOX, AND THE BLACK AND BLACK/WHITE WIRES ON THE

B. AFTER MAKING THE WIRE CONNECTIONS, THE WIRES SHOULD BE SPREAD APART WITH THE WHITE AND

NO BARE WIRE OR WIRE STRANDS SHOULD BE VISIBLE AFTER MAKING CONNECTIONS.

GENERAL-USE SWITCH.

STRIPE TO THE WALL SWITCH LEAD. THE WALL SWITCH MUST BE ACCEPTABLE FOR USE AS A

IF A SEPARATE WALL SWITCH WILL BE USED TO CONTROL THE LIGHT, CONNECT THE BLACK WIRE WITH WHITE

CONNECT THE GROUND WIRE TO THE GREEN LEADS FROM THE MOTOR AND CEILING PLATE. SEE FIGURE 6.

STRIPE MOTOR LEAD (SEE NOTE). CONNECT THE WHITE ELECTRICAL SUPPLY LEAD TO THE WHITE MOTOR LEAD.

CONNECT BLACK ELECTRICAL SUPPLY LEAD TO THE BLACK MOTOR LEAD AND THE BLACK WITH WHITE

A. CONNECT ELECTRICAL SUPPLY LEADS TO THE LEADS FROM MOTOR, USING APPROVED CONNECTORS.

FINAL WIRING

CAUTION:

STEP 7:

FAILURE TO SECURELY ASSEMBLY THE CANOPY SCREWS COULD RESULT IN THE FAN FALLING.

(3) SCREWS SECURELY.

ROTATE FAN COUNTERCLOCKWISE UNTIL ALL (3) MOUNTING SCREWS DROP INTO SLOT RECESSES. TIGHTEN

PLATE. LIFT FAN UNTIL CEILING PLATE MOUNTING SCREWS (3) ARE SEATED IN BOTTOM OF SLOTS IN CANOPY.

B. POSITION (3) SLOTS IN CANOPY DIRECTLY UNDER AND IN LINE WITH (3) MOUNTING SCREWS IN CEILING

THE CANOPY HAS (3) MATING SLOTS. SEE FIGURE 7.

REMOVE THE FAN FROM THE CEILING PLATE HOOK. MAKE SURE NOT TO BREAK ANY WIRE CONNECTIONS.

PHILLIPS ROUND HEAD SCREWS HALFWAY INTO THESE HOLES. SEE FIGURE 7.

A. THE CEILING PLATE HAS (3) MOUNTING SCREW HOLES LOCATED ON THE SIDE. INSTALL (3) #10-32 X 1/2"

FINISH FAN ASSEMBLY

ENGAGES TAB IN CANOPY

ROTATE BALL UNTIL GROOVE IN BALL

LEAD WIRES

GROOVE IN BALL

PIPE NIPPLE

CANOPY

FIGURE 7A.

CEILING PLATE

GREEN GROUND WIRE

FIGURE 6.

CEILING

CEILING PLATE

GROUND WIRE

CANOPY

ADAPTOR

FAN ASSEMBLY

LOCTITE ON THREADS

LOCKWASHERS AND

SCREWS WITH

SCREW HOLE

SCREW HEAD

CANOPY

FIGURE 5.

SETSCREW (TIGHTEN

PIPE NIPPLE

CANOPY

MOTOR

PIPE NIPPLE

LEAD WIRES

6" MIN