Hunter Fan 42605-01 Manuel D’Utilisation

Hunter Fan Company 

42605-01 • 02/16/06

42605-01 • 02/16/06 

Hunter Fan Company

 

4-1.  Raise the fan and align the slots in the canopy with the hooks on the 

ceiling plate.

    Note: To hang the fan, you must tilt the canopy to an almost vertical 

position so that the canopy slots sit on the ceiling plate hooks. 

All wiring must be in accordance with national and local electrical 
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a 
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch in 
accordance with national and local electrical codes.
4-2.  Make sure the power to the outlet box and associated wall switch 

location is still OFF.

    To connect the wires, hold the bare metal leads together and place a 

wire nut over them, then twist the wire nut clockwise until tight.

     

 CAUTION:  Be sure no bare wire or wire strands are visible after 

making connections.

    Single Switch Wiring: 
    If you want to, you can control both fan and light with one switch. To 

do so connect the wires as follows: 

• e bare or green ground wire from the ceiling to the green 

ground wire from the ceiling plate and the green ground wire 
from the fan

• e white wire from the ceiling to the white wire from the fan
• e black wire from the ceiling to the black and the black/white 

wire from the fan 

    Dual Switch Wiring: 
    •  e bare or green ground wire from the ceiling to the green  

 

  ground wire from the pipe ball assembly

• e white wire from the ceiling to the white wire from the fan
• e black wire from the ceiling to the black wire from the fan
• e black/white wire from the fan to the wire for the wall switch

4-3.  Push all wires and wire nuts into the outlet box.

Wire Nut