Hunter Fan 42605-01 Manuel D’Utilisation

Hunter Fan Company

42605-01 • 02/16/06

Hunter Fan Company

5 • Installing the Canopy and Canopy Trim Ring

WARNING: Failure to complete the following steps could cause the fan

to fall.

Note: It is recommended you use a magnetic tip screwdriver for the
following steps.
5-1. Rotate the hanger ball so the tab in the canopy is secure in the

hanger ball groove. Note: Your fan may have multiple tabs and
grooves that must be aligned.

5-2. Swing the fan up to align the canopy screw holes with the

mounting holes on the ceiling plate.

WARNING: e slots in the canopy must remain engaged while

swinging the canopy for alignment.

5-3.  Holding the canopy up with the screw holes aligned, partially
    install two canopy screws into the holes opposite the ceiling plate
    tabs.
5-4.  Partially install a canopy screw between the slots in the canopy.
    When all the holes are properly aligned, securely tighten all three
    canopy screws.
5-5.  Verify that the tabs in the canopy are still in the grooves of the

hanger ball.

5-6. Align the tabs on the trim ring opposite the grooves in the hanger

ball. Using both hands, push the canopy trim ring up to the top of
the canopy. e canopy trim ring will snap and lock into place.

Note: Should you need to remove the trim ring, press firmly on

opposite sides of the trim ring directly above the groove in the
hanger ball. e tabs will flex out releasing the canopy trim ring.

Step 5-1

Step 5-2

Groove

Tab

Step 5-3

Canopy Screw

Canopy

Trim

Ring

Canopy