Regency Wraps I2400M Manuel D’Utilisation

Regency I2400M 

12

ensure the tube will not move when the unit 
is burning. Though there are  four air tubes 
in the medium units.

2)  Slide the left baffl e over the air tubes from 

the front and then push it to the  back. 

3)  Tilt the left baffl e up on top of the side chan-

nel and it will leave enough room to position 
the right baffl e in the same manner as Step 
1) above. Then reposition the left baffl e fl at 
on the air tubes.  

Before establishing your fi rst fi re, it is important 
that your fully understand the operation of you 
draft control. The draft rod is on the left side of 
the Inserts and it controls the intensity of the fi re 
by increasing or decreasing the amount of air 
allowed into the fi rebox. To increase your draft 
- pull open, and to decrease - push closed.

As well as a primary and glass wash air system, 
the unit has a full secondary draft system that 
allows air to the induction ports at the top of the 
fi rebox, just below the fl ue baffl e.

The unit arrives with the  2 baffl e plates on the 
fl oor of the fi rebox. 

1)  If all 4 air tubes are installed continue on 

to Step 2), if not, follow the instructions 
below. Install the air tube into the holes in 
the side channels. The notch goes on the 
right hand side with the air holes facing 
toward the door. Slide the tube into the left 
hand side, as far as possible and then bring 
it back into the hole on the right hand side.  
Use a pair of vise grips or pliers and tap it 
into place with a hammer.  A tighter fi t will 

The fl ue baffl e system located in the upper area 
of the fi rebox is removable to make cleaning your 
chimney system easier.  The  baffl es must be 
installed prior to your fi rst  fi re.  Smoke spill-
age and draft problems may occur if  the 
baffl es are improperly positioned.  Check 
the position of the baffl es on a regular basis as 
they can be dislodged if too much fuel is forced 
into the fi rebox. 

Please check to ensure that your fl oor protection 
and hearth will meet the standards for clearance 
to combustibles. Your hearth extension must be 
made from a non-combustible material.

Firebrick is included to extend the life of your 
insert and radiate heat more evenly.  Check to 
see that all fi rebricks are in their correct posi-
tions and have not become misaligned during 
shipping.  

Hook screen to the inside on the right side 
of the fi rebox door opening. Lock in place by 
turning handle.

Attach spring handle by rotating counter clock-
wise onto rod.  Ensure that the rod fi ts into the 
entire length of the spring handle. 

NOTE: The handle must be positioned at 10 
o'clock when closed to avoid the handle from 
getting hot and to ensure the screen stays in 
place.