New Buck Corporation GAS STOVE HEATER Manuel D’Utilisation

INSTALLATION

Continued

STOVE CAVITY ASSEMBLY

1. Lift off corrugated box enclosing

stove body crating.

2. Remove all screws fastening the

wood frame enclosure. Spread
wood frame open and lift away
from plastic-bagged stove body.
The bottom pieces of pallet wood
will remain bolted to the stove
body.

3. Remove plastic bag from stove

body.

4. Remove back panel from stove, if

equipped (See Figure 5). Use an
adjustable wrench or a 10 mm
socket. Remove six (6) bolts and
washers. Keep bolts and washers
to reattach back panel later.

5. Remove all contents from inside

stove cavity. Contents include:

(4) - Legs (includes leg leveler

bolts)

(1)   - Bottom door
(3)   - Top grates
(1)  - Hardware kit bag with

fasteners

6. Carefully lay stove body on back

to attach bottom components to
stove body (See Figure 6). Rest
stove on drop cloth or blanket to
avoid scratching stove edges.

7. Remove remaining pallet wood

attached to bottom of stove body
(See Figure 6). Use an adjustable
wrench to remove bolts.

CAUTION:

Cast Iron is brittle.

Do not over-tighten bolts or
screws during assembly.
8.

Fasten each leg to stove with four
(4) M8 x 1.25—20 mm bolts. Use
a flat washer and lock washer with
each bolt. Tighten bolts into
threaded holes on stove body (See
Figures 7 and 8). Use an adjustable
wrench or a 12mm socket.

BOLT

BACK STOVE
PANEL

FIGURE 5 - REMOVING BACK PANEL

FIGURE 6 - LAYING DOWN STOVE ON SIDE

TOP OF
STOVE
UNIT

FRONT OF
STOVE UNIT

DROP CLOTH/
BLANKET

REMOVE PALLET
BOLTED TO
STOVE BOTTOM

BOTTOM OF
STOVE UNIT

LEG
HOLE

DOOR CATCH BOLT
WITH ADJUSTABLE
HEX NUTS HOLE

FRONT

DOOR HINGE STEP
BOLT HOLE

LEG
HOLE

FIGURE 7 - LOCATING THREADED HOLES FOR STOVE BOTTOM,LEGS

NOTE:

CVF200’s series are

not equipped with a back panel.