Outback Power Systems Outback Power Systems Manuel D’Utilisation

                    

Copyright 2003  

  OutBack Power Systems, Inc. 

 

                                                                                     19009 62

nd

 Ave NE, Arlington   WA 98223 USA                       

Page 10                                         

Rev 7.0       07/02/04                                                                    Tel 360 435 6030     Fax 360 435 6019  

 
All OutBack FX’s can be mounted in any position.  Better performance will be achieved if it is mounted in a location which allows for air 
to circulate around the exterior of the casting.  Locating the FX in a cool location will improve the operation and ensure the highest 
efficiency and power capacity.   

The following drawing provides the mounting and overall dimensions of the FX with the FXA kit (DCC + ACA + DCA) attached.  The 
first dimension is inches and the second value in parenthesis is the metric value in millimeters. 

  

Depth out from Wall / Height up from Shelf:   11.87 inches (301 mm) / 12.87 INCHES (327mm) with Turbo installed 

For installations where the FX may be exposed to water spray, either mount the FX with the base down (shelf mounting) or with the AC 
wiring compartment at the bottom (wall mounting).  This will minimize the entry of water into the AC wiring compartment.     

The FX-ACA can be used to add an AC outlet and one or two of OutBack’s AC rated OBDC circuit breakers (up to 70 amps max).  
When these items are added to the FX, it should only be used in an area that is protected from rain. 

 

Side view of FX with FXA kit attached.  The Turbo Kit adds 1” (25mm) additional height to achieve a total height of 12.87” (327mm)

ACA 

DCC

DCA 

AC Outlet or 
Circuit Breakers