ZyXEL Communications 1000 Manuel D’Utilisation
Chapter 7 Tutorials
ZyWALL USG 1000 User’s Guide
165
An Ethernet switch connects both ZyWALLs’ ge1 interfaces to the LAN. Whichever
ZyWALL is functioning as the master uses the default gateway IP address of the
LAN computers (192.168.1.1) for its ge1 interface and the static public IP address
(1.1.1.1) for its ge2 interface. If ZyWALL A recovers (has both its ge1 and ge2
interfaces connected), it resumes its role as the master and takes over all of its
functions again.
ZyWALL is functioning as the master uses the default gateway IP address of the
LAN computers (192.168.1.1) for its ge1 interface and the static public IP address
(1.1.1.1) for its ge2 interface. If ZyWALL A recovers (has both its ge1 and ge2
interfaces connected), it resumes its role as the master and takes over all of its
functions again.
Figure 127 Device HA: Master Fails and Backup Takes Over
Each ZyWALL’s ge1 interface also has a separate management IP address that
stays the same whether the ZyWALL functions as the master or a backup. ZyWALL
A’s management IP address is 192.168.1.3 and ZyWALL B’s is 192.168.1.5.
stays the same whether the ZyWALL functions as the master or a backup. ZyWALL
A’s management IP address is 192.168.1.3 and ZyWALL B’s is 192.168.1.5.
Figure 128 Device HA: Management IP Addresses
7.14.1 Before You Start
ZyWALL A should already be configured. You will use device HA to copy ZyWALL
A’s settings to B later (in
A’s settings to B later (in
). To avoid an IP address
conflict, do not connect ZyWALL B to the LAN subnet until after you configure its
device HA settings and the instructions tell you to deploy it (in
device HA settings and the instructions tell you to deploy it (in
).
A
192.168.1.1
B
LAN
192.168.1.1
1.1.1.1
1.1.1.1
A
B
LAN
192.168.1.3
192.168.1.5