Toshiba B-SA4TM SERIES Manuel D’Utilisation

ENGLISH VERSION EO1-33047 

2. PRINTER SETUP

E2- 1 

This section outlines the procedures to setup your printer prior to its operation.  The section includes precautions, 
loading media and ribbon, connecting cables, setting the operating environment of the printer, and performing an 
online print test. 
 

 

 

 

 

 

 

 

 

After referring to the Safety Precautions in 
this manual, install the printer on a safe and 
stable location. 

Connect a power cord to the power inlet of 
the printer, then, to an AC outlet. 

Load a label stock or tag stock.

Adjust the position of feed gap sensor or 
black mark sensor according to the media to 
be used. 

In case of thermal transfer printing, load the 
ribbon. 

Connect the printer to a host computer or a 
network. 

Set the printer parameters in the system 
mode. 

Installation 

Connecting the power cord

Loading the media 

Setting the operating 

environment 

Media sensor position 

alignment 

Loading the ribbon 

Connecting to a host computer 

Make a print test in your operating 
environment and check the print result.   

Print test 

Automatic threshold setting 

Manual threshold setting 

If necessary, install the printer driver in your 
host computer.  

Installing the printer driver 

If the print start position cannot be detected 
properly when pre-printed label is used, set 
the threshold automatically.  

If the print start position cannot be detected 
properly even an automatic threshold setting 
is performing, manually set the threshold.  

Turn on the printer power.

Turning the power ON 

Position and Print Tone Fine 

adjustment 

If necessary, fine adjust the print start 
position, cut/strip position, print tone, etc.