Toshiba B-SA4TM SERIES Manuel D’Utilisation

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.2 Connecting the Power Cord

E2- 2

2.1 Installation

2.1.1 Attaching the Printer

Rear Support

2.2 Connecting the

Power Cord

To insure the best operating environment, and to assure the safety of the
operator and the equipment, please observe the following precautions.
• Operate the printer on a stable, level, operating surface in a location

free from excessive humidity, high temperature, dust, vibration or
direct sunlight.

• Keep your work environment static free. Static discharge can cause

damage to delicate internal components.

• Make sure that the printer is connected to a clean source of AC

Power and that no other high voltage devices that may cause line
noise interference are connected to the same mains.

• Assure that the printer is connected to the AC mains with a three-

prong power cable that has the proper ground (earth) connection.

Attach the supplied Printer Rear Support to the bottom of the printer back
with the SMW-4x8 screw, as shown in the picture below.

1. Make sure that the printer Power Switch is in the OFF (

{

)

position.

Connect the Power Cord to the printer as shown in the figure below

2. Plug the other end of the Power Cord into a grounded outlet as shown

in the figure below.

[Example of US Type]

[Example of EU Type]

CAUTION!

As a Power Cord is not supplied
with the printer, please purchase
an approved on that meets the
safety standard of each country.
(Refer to APPENDIX 3.)

Power Cord

Power Switch

Printer Rear Support

SMW-4x8

NOTE:

The Printer Rear Support can be
attached in either way of A or B.
But A is more stable than B.
A

Power Cord