Hearth & Home Technologies GO24MTCH Manuel D’Utilisation

Hearth & Home Technologies • Grand Oak Match Light Gas Log Sets • 4004-300 Rev C • 12/05

3

The Gas Log Hearth Kit consists of the following:

• Log 

Set

• Burner/Pan 

Assembly

• Grate 

Assembly

• Rock 

Wool

• Sand
• Lava 

Rock

• Damper 

Stop

• Vermiculite
• Platinum 

Embers

Tools and supplies normally required for installation:

Pliers
Phillips screwdriver
Tape measure
Crescent wrenches
Gas shutoff valve
Non-corrosive leak check solution
3/4 in. wrench, 7/16 in. wrench

Improper installation, adjustment, alteration, service 
or maintenance can cause injury or property damage. 
Refer to the owner’s information manual provided with 
this appliance. For assistance or additional information 
consult a qualifi ed installer, service agency or the gas 
supplier.

Sharp Edges
•  Wear protective gloves 

and safety glasses during 
installation.

HOT! DO NOT TOUCH. 
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.

• Keep 

children 

away. 

 

•  CAREFULLY SUPERVISE children in same room as 

appliance.

•  Alert children and adults to hazards of high 

temperatures.

•  Keep clothing, furniture, draperies and other 

combustibles away. 

Glass and other surfaces are hot during 
operation and cool down.

•  Do not remove any of the attached metal plates, which 

contain important safety and operating information.

•  Keep the appliance area clear and free of all combustible 

materials, gasoline and other fl ammable vapors and 
liquids.

• 

Any safety screen or guard removed during servicing must 
be replaced before operation.

•  A qualifi ed service technician must perform installation 

and repair. The appliance should be inspected and cleaned 
annually by a qualifi ed service technician. More frequent 
cleaning may be required due to excessive lint, dust, pet 
hair, etc. It is imperative that the control compartments, 
burners and air passageways are unobstructed during 
operation.

- 

Review proper placement of logs, rockwool, lava rock 
and vermiculite.

- Check 

the 

wiring.

-  Ensure there are no gas leaks. 
- Ensure 

the 

fl ow of combustion and ventilation air is not 

obstructed (front grilles and vent caps).

•  Before installing into a solid fuel burning fi replace, the 

chimney and fi rebox should be inspected and cleaned to 
remove soot, creosote, ashes, paint, bird nests etc.

•  Annual examination of the chimney must be performed 

by a qualifi ed agency to ensure proper ventilation of fl ue 
gases created by this appliance.

Fire Risk
Exhaust Fumes Risk
• 

Do NOT use this appliance as a “vent-free 
heater.

The fl ue must be permanently open according 
to Tables 1 and 2.

•  Have the chimney and adjacent structure inspected 

and cleaned by qualifi ed professionals. Hearth & Home 
Technologies recommends that NFI or CSIA certifi ed 
professionals, or technicians under the direction of certifi ed 
professionals, conduct a minimum of an NFPA 211 Level 2 
inspection of the chimney.

• 

Replace component parts of the chimney and fi replace as 
specifi ed by the professionals.

• 

Ensure all joints are properly engaged and the chimmney 
is properly secured.

•  Do not allow fans to blow directly into the fi replace. Avoid 

any drafts that alter burner fl ame pattern.

• 

Do not use a blower insert, heat exchanger insert or other 
accessories not approved for use with this appliance.