Amana MMV1153BA Manuel De Montage

You need to drill holes for the top support screws, a 
hole large enough for the power cord to fit through, 
and a cutout large enough for the exhaust adaptor.

•

Read the instructions on the TOP CABINET 
TEMPLATE.

•

Tape it underneath the top cabinet.

•

Drill the holes, following the instructions on the 
TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes 
in the cabinet bottom.

Carefully slide the blower motor toward the right, 
and lift it partially out of the opening. 
Note: The blower wires are long enough to allow 
flexible handling while performing these steps. 
Disconnect the wires if necessary for additional 
flexibility.

Remove the two screws holding the left side inlet 
sleeve to the blower unit. Snap the inlet sleeve 
off of the blower.

Roll the blower unit so that the right exhaust 
outlet faces the top. Snap the inlet sleeve back 
onto the left side with the opening facing down. 
Note: The left side sleeve opening must always 
face downward. Reinstall the 2 screws holding 
the inlet sleeve to the motor assembly.

Tilt and place the blower unit back into the 
opening in the top of the microwave.

Remove
screws

Remove the back top center blower motor door 
retaining screw.

Open the blower motor door by lifting it up at the 
back side of the microwave. Remove and save 
the top and back retaining screws that hold the 
blower motor in the microwave.

Blower Motor

Back of 
Microwave

Blower Motor
Screw

Retaining
Screw

Retaining
Screw