Amana MMV1153BA Manuel De Montage

Secure the blower unit to the microwave with the 
two screws removed in Step 2.

Close the blower cover and secure it with the 
screw removed in Step 1.

Attach the exhaust adaptor to the rear of the 
microwave by sliding it into the guides at the top 
center of the back of the oven.

FOR EASIER INSTALLATION AND PERSONAL 
SAFETY, WE RECOMMEND THAT TWO PEOPLE 
INSTALL THIS MICROWAVE OVEN.

NOTE: If your cabinet is metal, use the nylon 
grommet around the power cord hole to prevent 
cutting of the cord.

NOTE: We recommend using filler blocks if the 
cabinet front hangs below the cabinet bottom shelf.

NOTE: When mounting the microwave oven, thread 
power cord through hole in bottom of top cabinet. 
Keep it tight throughout Steps 1–3. Do not pinch cord 
or lift oven by pulling cord.

Insert a self-aligning screw through top left 
cabinet hole. Temporarily secure the oven by 
turning the screw at least two full turns after the 
threads have engaged. (It will be completely 
tightened later.) Be sure to keep power cord 
tight. Be careful not to pinch the cord, 
especially when mounting flush to bottom of 
cabinet.

Rotate front of oven up 
against cabinet bottom

Lift microwave, tilt it 
forward, and hook slots
at back bottom edge 
onto four lower tabs of 
mounting plate.

Retaining
screw

Retaining
screw

Back of
Microwave

•

Place the microwave in its upright position, with 
the top of the unit facing up.

•

This microwave oven may be shipped 
assembled for top exhaust (adaptor installed) or 
for recirculation exhaust (adaptor absent).

•

You will need to make adjustments to assure 
proper alignment with your house exhaust duct 
after the microwave is installed.

Exhaust Adaptor
(absent on models shipped
for recirculation exhaust)