Haier dwe-3120a Manuel D’Utilisation

The exit end face of the faucet

water faucet, suitable                                                                                              water faucet, not suitable

It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.

2 Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. 
   See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen 
   the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise 
   it may leak water. See to Figure 3.)

1.

Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the

   water inlet hose component. See to Figure 1.

3.

Fasten the four screws evenly. See to Figure 4.

about 4mm after twisting

Remark: .Before twisting the fastening nut, the threading is 4mm above the upper 
surface of the nut. After twisting, the threading is less than 2mm above the upper
 surface of the nut. See to Figure 6

About above  2mm after twisting

water inlet hose jointer

water inlet hose jointer

Screw knife

Screw

Bushing

Nameplate

Screw nut

water inlet hose 

Figure 1

Figure 4

Figure 2

Figure 5

Figure 3

Figure 6

Slider

Lock level 

Install the water inlet hose

4 Take off the nameplate. Twist the fastening nut as per the indication of the figure
   to seal up the exit end face of the faucet. See to Figure 5.