Zanussi ZKG44500XA Manuel D’Utilisation

END

To set when the appliance must deactivate. Use only when an

oven function is set. You can use Duration and End at the

same time (time delay), if the appliance is to be activate and

deactivate automatically later.

Press   again and again to switch

between the clock functions.

To confirm the settings of the clock
functions, press   or wait 5

seconds for an automatic

confirmation.

1. Press   again and again until the display

shows 

 or 

.

 or 

 flashes in the display.

2. Press   or   to the set the values and

press   to confirm.

For Duration 

 first you set the minutes and

then the hours, for End 

 first you set the

hours and then the minutes.

An acoustic signal sounds for 2 minutes after
the time ends. 

 or 

 symbol and time

setting flash in the display. The oven stops.

3. Turn the knob for the oven functions to the

off position.

4. Press any button or open the oven door to

stop the acoustic signal.

If you press   when you set the
hours for DURATION 

, the

appliance goes to setting of the
END 

 function.

1. Press   again and again until   and "00"

flash in the display.

2. Press   or   to set the MINUTE

MINDER. 

First you set the seconds, then the minutes

and then the hours.

At first, the time is calculated in minutes and

seconds. When the time you set is longer
than 60 minutes, the symbol 

 comes on

in the display.

The appliance now calculates the time in hours

and minutes.

3. The MINUTE MINDER starts automatically

after five seconds. 

After 90% of the set time, an acoustic

signal sounds.

4. When the set time ends, an acoustic signal

sounds for two minutes. "00:00" and 

flash in the display. Press any button or

open the oven door to stop the acoustic

signal.

If you set the MINUTE MINDER

when the DURATION or END
function operates, the symbol 

comes on in the display.

Use the Count Up Timer to monitor how long

the oven operates. It is on immediately when the

oven starts to heat.

To reset the Count Up Timer, press and hold 
and  . The timer starts to count up again.

The Count Up Timer cannot be used
with the functions: Duration 

,

End 

.

Refer to Safety chapters.

Wire shelf: