buell s1 lightning '97 Manuel

 

13. See 

 Check for OPEN FIELD COILS with an

ohmmeter or continuity tester. Touch one probe to the
field wire. Touch the other probe to each of the brushes
attached to the field coils. There should be continuity. If
there is no continuity at either brush, then the field coil(s)
are open and the field frame must be replaced.

14. See 

 Test BRUSH HOLDER INSULATION

with an ohmmeter or continuity tester. Touch one probe
to holder plate. Touch the other probe to each of the pos-
itive (insulated) brush holders. There should be no conti-
nuity (infinite ohms). If there is continuity at either brush
holder, replace the brush holder assembly.

15. See 

 Check armature bearings (8) and

replace if necessary.

16. See 

 Remove two drive housing mounting

screws (with washers and lockwashers). Remove drive
housing from solenoid housing.

17. See 

 Remove drive (1), idler gear (2), idler

gear bearing (3), and O-ring (4) from drive housing (O-
ring is located in drive housing groove).

 

1.

See 

 Clean, inspect and lubricate drive

assembly components. Lubricate parts with high temper-
ature grease, such as LUBRIPLATE 110.

2.

See 

 When installing drive assembly compo-

nents, open end of idler bearing cage (15) faces toward
solenoid.

3538a

1787a

3549a