RAD Data comm ASM-60 Manuel D’Utilisation

Chapter 4  Management from a Terminal 

ASM-60 Installation and Operation Manual 

4-6 

Displaying the ASM-60 System Information

 

 

You can display the current status of the local and remote ASM-60 modems. 

 

To display the ASM-60 status: 
•  From the Display menu, type 1. 

The Status screen is displayed (see 

Status 

Device Rate: 6144 kbps 

Remote Status: ASM60/SA CO 

Active Software Version: 01.00 

Hardware Version (PCB): 00 

AFE Version: 00.00 

DTE Interface Type: ETH_UTP 

DCD Status: FAILED 

Line A Lock Status: SYNC LOSS 

Line B Lock Status: SYNC LOSS 

Test Mode: NO TEST 

 

Press any key to return to previous menu... 

0. Sync Line A is COMPLETE 

1. Sync Line B is COMPLETE 

 

> 

ESC - previous menu ; ! - main menu ; & - exit terminal 

------------------------------------------------------- 
 

The Status screen provides the following information on ASM-60: 
•  Device rate – The current date rate of ASM-60 
•  Device type – ASM-60 type (ASM-60/CO or ASM-60/CPE) 
•  Active software version – Revision the software currently being used by 

ASM-60 

•  Hardware version (PCB) – The H/W revision of the ASM-60 main board 
•  AFE version – The Analog Front End revision 
•  DTE interface type – The ASM-60 DTE interface and its connector type 
•  DCD status – Data Carrier Detect status, indicating if the line A, line B and the 

IMUX are synchronized 

•  Line A lock status – The synchronization status of the 2-wire line A 
•  Line B lock status – The synchronization status of the 2-wire line B 
•  Test mode – The current status of the diagnostic test (active or not active). 

↓ 2 

↓ 1