RAD Data comm ASM-60 Manuel D’Utilisation

Page de 90
ASM-60 Installation and Operation Manual 
Appendix C  IR-IP Interface Module 
 
IR-IP Management Utility 
C-9 
C.6  IR-IP Management Utility 
General Operating Procedures 
The IR-IP interface module is managed via a simple, menu-driven utility that uses a 
basic terminal user interface. A typical screen is shown in 
As seen in 
, each screen has a header that identifies the device being 
configured and its logical name, assigned by the user, followed by the running 
software revision and date. The bottom line of the screen displays prompts that 
guide you in the execution of the various activities. 
Use the following general procedures to perform the desired activity: 
•  To change a parameter or to select a menu item, type the corresponding line 
number. 
•  For a parameter, which has a discrete set of values, the parameter values are 
enclosed in brackets [ ]. To select a new value, press the spacebar to scroll 
among the available values until the desired value is displayed, and then press 
<Enter>
 to select the displayed value. 
•  To enter a value which requires free text entry, type in the desired string and 
then press <Enter>. Use backspace to erase the current string. 
•  After all the parameters have been selected, a prompt appears, requesting that 
you confirm the changes. 
 
For proper display of the screens, you must: 
•  Select a fixed-pitch system font for the display. Use your operating system 
documentation to find how to select a proper font. 
•  Configure the Telnet utility to use VT-100 terminal emulation. 
 
Starting a Management Utility 
The management utility is started automatically when Telnet communication is 
established. If password protection is enabled (see the 
section below), you will be prompted to enter the Telnet password. The opening 
screen, which appears after the Telnet session activation, is the IR-IP Main menu 
(see 
IR_IP 
 
<IR-IP> 
S/W Ver. 1.00 31/IR (date) 
 
1. Quick Setup 
2. Management Access 
3. Advanced Setup 
4. Device Control 
5. View 
6. Diagnostic Tool (PING terminal) 
 
Press one of the numbers to select or ESC: 
Figure C-4.  IR-IP Main Menu 
To end the utility, press <Esc> when the Main menu is displayed. This will also 
end the Telnet session. 
Note